You/and or all Participants involved agree to the terms, conditions and disclaimer set forth by your credit card authorization and opening of the materials enclosed.

You will get 3 days with the fender roller for the agreed price. Once UPS sends confirmation for signed package, your time will begin. Day 4, you must send the fender roller back to us with all parts and in working condition. Each additional day late you will be charged $10 per day. The fender roller will come with instructions and parts list. Upon opening the package, you will have agreed to all terms and conditions. There will also be a $300 dollar deposit held on your card until fender roller is returned.

Safety:

Be sure to observe all applicable safety precautions prior to and during the use of this equipment. Applicable safety precautions include, but are not limited to:
- Properly raising and supporting of the vehicle.
- Wearing of appropriate eye and hand protection.

Additional Tools Required:
The following items should be present and in proper operating condition to conduct the fender rolling operation.

- Floor Jack
- Jack Stands
- Heat Gun
- Manual lug wrench for wheel lugs

Instructions for Use:

1. Raise and support either entire vehicle or vehicle corner on which fender rolling operation is to occur.
2.  Remove wheel and place hub flange portion of the Fender Roller over wheel lugs. Place the dished washers (included) onto the wheel lugs. Use wheel nuts to hold tool in place; tighten snugly.
3. Loosen the hand wheel located on the arm of the tool and adjust the arm length     until the Fender Roller wheel is centered on the inner fender lip. Tighten the handwheel.
4.  Using the release lever, adjust the roller angle to match the desired shape that the inner lip will be formed.
5. Adjust the pressure bar to apply gentle pressure to the formed lip.
   • Use a heat gun to gently warm the paint in the area to be rolled (to prevent cracking). Under fender bottom lip. Do not use on outside of fender.
   • Grasp the tool firmly and repeatedly swing it in an arc across the inner fender lip to form the desired shape. It will be necessary to adjust the pressure bar to keep constant pressure on the lip during the operation. If the wheel arch radius is varying, it may be necessary to form the lip on small sections at one time, readjusting for each section radius.

   Please use all safety precautions when using this fender roller.

   

   Note: This is a fender lip roller not a fender flare machine. Please see the above picture for demonstration of fender rolling.

   Parts included:

   1. ESE Fender Roller       
   2. 5 Spacers                      
   3. Heat Gun  

   Please read:
   You and all parties involved in using or participating in using rental fender roller are bond by this disclaimer upon rental agreement and/or credit card authorization and/or opening of package.
   Please use all safety precautions when using this fender roller.

   Disclaimer:
   In no event will ESE Tuning LLC be liable for any damage or personal injuries whatsoever. Resulting from any way related to use of any products, materials posted on or made available on our website through rental, even if ESE Tuning LLC has been advised of the possibility of such damages and regardless of the legal theory on which such damages are based.
   No warranty whatsoever will be valid if the defect was caused by the customers abuse, negligence, or mishandling. All products/merchandise rented by ESE Tuning LLC is only subject to the manufactures warranty and conditions, if any, and is subject to submission to the manufacture for inspection and approval for repair or replacement of product/merchandise. Customer, however, will be responsible for all shipping and handling fees. No labor or inconvenience may be included in any warranty claims.

   Copyright 2007 ESE Tuning, LLC